Am Mittwoch, den 11.03.2015, 09:38 +0100 schrieb Sascha Hauer: > On Tue, Mar 10, 2015 at 08:59:08PM +0100, Lucas Stach wrote: > > Note: this only fixes the build failure, I haven't actually tested > > if it works. > > > > Signed-off-by: Lucas Stach <l.stach@xxxxxxxxxxxxxx> > > --- > > arch/arm/mach-highbank/smc.S | 1 + > > 1 file changed, 1 insertion(+) > > Applied all but this one. > > Could you tell us more about the build failure? It builds fine here with > thumb2 enabled. > The failure is this one: Error: selected processor does not support Thumb mode `smc #0' Now looking at this again it may not only hit the Thumb build, but also normal ARM mode builds. The check that is triggered here was only later introduced into binutils, I can't really point at a specific version though. So you may not see this error depending on your toolchain version. Regards, Lucas -- Pengutronix e.K. | Lucas Stach | Industrial Linux Solutions | http://www.pengutronix.de/ | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
