Good Evening, I wrote a small command to send a LLDP frame over the network. Then I tried to integrate this command into the start script but I noticed that while a message is printed on the console no actual packet is being sent on the wire. I am using a Phytec AM335X SoM and I am not on the latest version of barebox either so this might be something that is already fixed. My assumption is that when I use eth_get_current/eth_send the network is being activated. I had a quick look at the return code of eth_send to see if I could see that my packet has been dropped but in both success/failure the method returns 0. Is this to be expected? My interim solution is to add a sleep after the first command invocation and then do it again? Any ideas on how to properly address it? holger _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
