On Wed, 14 May 2014 12:59:53 +0800 Kevin Du Huanpeng <u74147@xxxxxxxxx> wrote: > yes,try > console.baundrate=9600 > but you may have to check if your serial driver has support this cs0.baudrate=9600 use devinfo to see all available consoles (cs0, cs1 etc). Also if you use advanced shell then use <tab> key, e.g. cs<tab>.bau<tab> > 在 2014-5-14，上午11:34，Fabio Estevam <festevam@xxxxxxxxx> 写道： > > > Hi, > > > > I am running barebox on a mx6qsabresd board and would like to know if > > there is a way to change the serial baudrate via barebox prompt. > > > > Any suggestion? > > > > Thanks, > > > > Fabio Estevam > > > > _______________________________________________ > > barebox mailing list > > barebox@xxxxxxxxxxxxxxxxxxx > > http://lists.infradead.org/mailman/listinfo/barebox > > _______________________________________________ > barebox mailing list > barebox@xxxxxxxxxxxxxxxxxxx > http://lists.infradead.org/mailman/listinfo/barebox -- -- Best regards, Antony Pavlov _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
