Hi, Le Thu, 13 Mar 2014 10:04:35 +0800, Sean Cross <xobs@xxxxxxxxxx> a écrit : > I've finally managed to get U-Boot's SPL to configure DDR3 and load > barebox off of a FAT partition on an i.MX6DL. I also have a barebox > build with most features turned on, and I'm running into a number of > problems. barebox is able to load a zImage off of the FAT partition, > set up ATAGs, and jump to it. So I have the basics done. But there are > lots of little things that aren't working. > > When I boot without an Ethernet cable plugged in, the "timeout" command > takes a very long time to complete. It generally freezes at "Hit any > key to stop autoboot: 3" and tends to ignore input for around ten > seconds. How can I prevent this from happening, short of compiling out > FEC support? > that's very similar to what I reported here : http://lists.infradead.org/pipermail/barebox/2014-February/018005.html I didn't yet had time to investigate more based on Sascha's answer but that's on my todo list. Eric _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
