Sascha, Part of my last post can be ignored -- specifically part of the stuff on the ethernet controller. I just discovered that using either "detect -a" or "detect miibus0" works to properly detect and configure /dev/phy0. Basically, the initial probe using devicetree fails, but once the PF0100 is set correctly and a simple manual reset is done (same code as you used on the pfla02), then the phy detects properly and I can access the network. So, is there an easy way to have it skip the initial probe that fails? Was this possibly the idea behind why you have the fec disabled in the pfla02.dtsi and then enable it in the pbab01.dts? Basically, disable it for the first probe, then enable it in an overlay and reprobe? What I have now "works", but I prefer to do things the "right way" if possible. Thanks! Michael Burkey _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox