This is needed when a phy gets registered outsize of phy_device_connect but has to be attached to an ethernet device later. Signed-off-by: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx> --- drivers/net/phy/mdio_bus.c | 8 -------- drivers/net/phy/phy.c | 9 +++++++++ 2 files changed, 9 insertions(+), 8 deletions(-) diff --git a/drivers/net/phy/mdio_bus.c b/drivers/net/phy/mdio_bus.c index b0fbf2d..84c05ad 100644 --- a/drivers/net/phy/mdio_bus.c +++ b/drivers/net/phy/mdio_bus.c @@ -181,14 +181,6 @@ static int mdio_bus_probe(struct device_d *_dev) dev->supported = drv->features; dev->advertising = drv->features; - ret = phy_init_hw(dev); - if (ret) - goto err; - - /* Sanitize settings based on PHY capabilities */ - if ((dev->supported & SUPPORTED_Autoneg) == 0) - dev->autoneg = AUTONEG_DISABLE; - dev_add_param_int_ro(&dev->dev, "phy_addr", dev->addr, "%d"); dev_add_param_int_ro(&dev->dev, "phy_id", dev->phy_id, "0x%08x"); diff --git a/drivers/net/phy/phy.c b/drivers/net/phy/phy.c index 74ef3d9..b05a313 100644 --- a/drivers/net/phy/phy.c +++ b/drivers/net/phy/phy.c @@ -306,6 +306,15 @@ int phy_device_connect(struct eth_device *edev, struct mii_bus *bus, int addr, edev->phydev = dev; dev->attached_dev = edev; + + ret = phy_init_hw(dev); + if (ret) + goto fail; + + /* Sanitize settings based on PHY capabilities */ + if ((dev->supported & SUPPORTED_Autoneg) == 0) + dev->autoneg = AUTONEG_DISABLE; + phy_config_aneg(edev->phydev); dev->adjust_link = adjust_link; -- 1.8.5.1 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
