Jan, thanks for the reply, I will look into using git-send-email a bit later since I am going to travel this morning fro a few hours. My question was however a little bit more generic. Take for example the PCM049 board.c file. One of the I2C components it loads is the TWL6030. If I wish to write to a register on this device, how would I go about it. By the way, I am using PHYTEC_PD13_Linux from pengutronix. It includes barebox-2013-06.0 Thanks for your help. Ivor On 2013/10/10 12:42 AM, "Jan Lübbe" <jlu@xxxxxxxxxxxxxx> wrote: >On Wed, 2013-10-09 at 18:59 -0700, Ivor Kruger wrote: >> But this is where my linux knowledge is letting me down. >> >> How do I get a "handle" to the device in order to call the write_reg >> function? >> >> Your pointers and help is much appreciated. > >Could you show us your code? That would make helping you much easier. >Please see 'man git-send-email' on how to send patches with git. > >Regards, >Jan >-- >Pengutronix e.K. | | >Industrial Linux Solutions | http://www.pengutronix.de/ | >Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | >Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | > > >_______________________________________________ >barebox mailing list >barebox@xxxxxxxxxxxxxxxxxxx >http://lists.infradead.org/mailman/listinfo/barebox _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
