-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hi, I restate this question from my previous thread "how to flash and set root variable". Thanks very much to Sascha and Alexander for introducing into barebox building and flashing. I have a basic scenario. Want to boot uImage and then hand over to the root partition. With u-Boot this was very easy: setenv bootargs "console=tty0 console=ttymxc0,115200n8 root=/dev/mmcblk0p3 rootfstype=ext4 rootwait ro" With barebox however, when I boot the uImage, it complains about not setting correct "root=".: [ 1.718527] VFS: Cannot open root device "(null)" or unknown-block(0,0): error -6 [ 1.726226] Please append a correct "root=" boot option; here are the available partitions: Now what i do in Barbox is the following; (hint enter to go into console) barebox@myhost:/ mkdir /media2 barebox@myhost:/ mount /dev/disk0.1 fat /media2 barebox@myhost:/ bootm /media2/uImage root=/dev/mmcblk0p3 rootfstype=ext4 I get the error with block (0,0). How can I change this? Thank you very much for help. Adam -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.12 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/ iEYEARECAAYFAlHUJ+QACgkQefEEI87R1DfOGQCePJk92+Z6RtUv9dbIq+LoG2tn SwQAoM/xi9tVVtGjxEpmxym0FxAI+BIn =fOuD -----END PGP SIGNATURE----- _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
