Le Wed, 8 May 2013 19:11:32 +0200, Jean-Christophe PLAGNIOL-VILLARD <plagnioj@xxxxxxxxxxxx> a écrit : > Hi, > > same > > barebox 2013.05.0-00119-g57955f2 #613 Thu May 9 01:12:00 CST 2013 > > > Board: Atmel at91sam9x5-ek > AT91: Detected soc type: at91sam9x5 > AT91: Detected soc subtype: at91sam9x25 > Clocks: CPU 400 MHz, master 133 MHz, main 12.000 MHz > netconsole: registered as cs2 > CM: SAM9X25-CM [B2] from RONETIX > EK: SAM9x5-EK [B0] from FLEX > DM: SAM9x5-DM [B0] from FLEX > sn: 0x4010465, rev: 0x10421 > atmel_nand: Use On Flash BBT > nand: no valid ONFI param page found > nand: Manufacturer ID: 0xad, Chip ID: 0xda (Hynix NAND 256MiB 3,3V 8-bit), page size: 0, OOB size: 0 > atmel_nand atmel_nand0: Initialize PMECC params, cap: 2, sector: 512 > nand: No oob scheme defined for oobsize 0 > BUG: failure at /opt/work/barebox/drivers/mtd/nand/nand_base.c:1642/nand_scan_tail()! > BUG! > no stack data available > behaviour should be different with v3 (I had an error in v2) Eric _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
