Hi, On Thu, Apr 25, 2013 at 4:09 AM, Uladzimir Bely <u.bely@xxxxxxxxxxxxxxxxx> wrote: > Since commit > 8bafdc1 ARM i.MX28: make chip reset via reset pin work again > > Patch adds basic OMAP5 support to barebox. > > Tested on SD card with 2 partitions: vfat (MLO, barebox.bin, zImage) > and ext3 (rootfs). Barebox successfully starts kernel > from commandline with "bootm /boot/zImage" command. > > Building MLO: make omap5_sevm_xload_defconfig; make. > Building barebox.bin: make omap5_sevm_defconfig; make. > > It's an optimized and cleaned up version of previous patch. Our upstream kernel support will be DT-only :). Further, OMAP5 ES2.0 SEVM does not exist. ES1.0 is few initial samples for development purposes - there are drastic differences in base addresses etc for OMAP5 ES2.0. If providing support for ES2.0, please use uEVM as reference platform. ES1.0 was meant to be in-development processor - no longer produced and definitely meant to be replaced with ES2.0. <snip> Regards, Nishanth Menon _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
