Am Montag, den 08.04.2013, 17:03 +0400 schrieb antonynpavlov@xxxxxxxxx:
> On Mon, 08 Apr 2013 14:24:06 +0200
> Lucas Stach <dev@xxxxxxxxxx> wrote:
>
> > Am Montag, den 08.04.2013, 15:46 +0400 schrieb antonynpavlov@xxxxxxxxx:
> > > On Mon, 08 Apr 2013 12:57:26 +0200
> > > Lucas Stach <dev@xxxxxxxxxx> wrote:
> > >
> > > > Hi Antony,
> > > >
> > > > Am Freitag, den 05.04.2013, 00:32 +0400 schrieb antonynpavlov@xxxxxxxxx:
> > > > > On Tue, 2 Apr 2013 08:19:10 +0200
> > > > > Lucas Stach <dev@xxxxxxxxxx> wrote:
> > > > >
> > > > > > ODMdata tells us which UART to use for debugging purposes. This is
> > > > > > agreed upon in both the upstream Linux kernel and U-Boot, so do it the
> > > > > > same way in barebox.
> > > > >
> > > > > This patch disables serial console on my Toshiba AC100.
> > > > >
> > > > Hm that's unfortunate, but I already suspected that your ODMdata might
> > > > be wrong.
> > > > What happens if you don't remove the serial init in your board? Do you
> > > > get a duplicate serial, or just your board defined one? If it still
> > > > works for you this way, we might take this as a compromise for now.
> > >
> > > IMHO, the right way is to get of_serial.c from linux and put some records
> > > like this
> > > uarta: serial@70006000 {
> > > compatible = "nvidia,tegra20-uart";
> > > reg = <0x70006000 0x40>;
> > > reg-shift = <2>;
> > > interrupts = <0 36 0x04>;
> > > nvidia,dma-request-selector = <&apbdma 8>;
> > > clocks = <&tegra_car 6>;
> > > status = "disabled";
> > > };
> > >
> > > to arch/arm/dts/tegra20.dtsi.
> > >
> >
> > No, this doesn't help with the decision which UART barebox should use
> > for it's output. This is a configuration option and therefore not
> > allowed to reside in the DT, so NVIDIA decided to put this information
> > into the ODMdata. Both U-Boot and the Linux kernel(for earlyconsole) use
> > the information stored in this location.
> >
> > You can always activate more consoles from board code or DT, but the
> > first/debug console should IMHO be handled the same way it's done in
> > Linux.
>
> Yes, this doesn't help to select the console UART, but it provide the
> information about platform available UARTs.
> The selection of console port is board-dependent (e.g. the chip can have
> many UARTs, but the board can use only one of them), so let's move this
> selection to board configuration section.
>
I see your point. Still I would like to be able to use the ODMdata on
boards that have a usable config there. I'll rework this patch to go the
same route as Linux earlyconsole config with a Kconfig select for the
DebugUART, where you can also opt to use the ODMdata defined one. I
think this will make everyone happy.
Regards,
Lucas
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
