>> I've just flashed barebox from the next tree onto a TX53-8030 module, >> and have to report, that the board won't boot. >> >> Currently I've tried to run it with MMU off and setting the text-base >> to 0x71000000, with no positive results. >> >> I'll do further investigation, but meanwhile does anyone have barebox >> running on a TX53 board? > > I just tested that it works for me as second stage. I can't test 1st > stage atm as I currently have no physical access to the board. Until now I've used bb in a 2nd stage configuration on top of the supplied Redboot, and it worked without any problem. Additionally I had CONFIG_MACH_DO_LOW_LEVEL_INIT disabled which skips another pll setup step, that was already done by Redboot. > Some guesses: Have you checked the correct the correct board revision in > the config? It's the default, so I assume it's correct. Yes, I did check for the correct board revision, and am using the correct one: CONFIG_TX53_REV_XX30=y > Are you using the barebox-flash-image link or barebox.bin? You have to > use the former because it's a compressed image. I've noticed, that the link target changes depending on build configuration. So I've flashed the file pointed to by barebox-flash-image. > You might want to disable compressed image support in > General settings -> > memory layout -> > [ ] pre-bootoloader image Just tried that, but without changed result. Currently I am trying to get my PEEDI JTAG probe working with the board, but until then I stay in the dark. Cheers, Christian _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
