On Fri, Sep 14, 2012 at 09:57:04AM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote: > > Adapt phylib from linux > > switch all the driver to it > > This will allow to have > - phy drivers > - to only connect the phy at then opening of the device > - if the phy is not ready fail on open > > Same behaviour as in linux and will allow to share code and simplify porting. > > Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@xxxxxxxxxxxx> > --- [...] + > +/* Automatically gets and returns the PHY device */ > +int phy_device_connect(struct mii_device *bus, int addr, > + void (*adjust_link) (struct mii_device *miidev)) The prototype of adjust_link seems wrong. A mii_device is a mii bus with potentially multiple phys. adjust_link should work on the phy_device. With the above, when a mii_device has multiple phys, a network driver has no way to figure out which phy has an updated link. This probably bites Renaud who has a single mii bus for multiple network devices. Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
