Hello Sascha,
thanks a lot for your help.
When I completely switch off the ecc, Barebox is loading the Linux kernel.
But I guess that the ecc is necessary especially for NAND-Flash devices.
The AT91SAM9263 controller has a ecc unit implemented. There are three
registers and the error calculation is done automatically, only the
error correction must be done in software.
Or is it better to you use the software ecc and I should try to fix the
software problem?
Can you give me some hints to fix this problem?
Btw. I have found the description table for the NAND devices. But what
would happen if I change the connections between the controller and the
NAND-Flash, where are those port description stored or the timings to
access the data bus?
best regards Sven
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
