Hi ! I try to upgrade a custom board from an old version(2009) of barebox to a new one. But I have some problems when the nand driver is loading(imx35_add_nand(&nand_info) After I boot with the old barebox, I use tftp to load the new version of barebox in ram and at run I get this on console : NAND device: Manufacturer ID: 0x2c, Chip ID: 0xdc (Micron NAND 512MiB 3,3V 8-bit) Bad block table not found for chip 0 Bad block table not found for chip 0 Scanning device for bad blocks Bad eraseblock 0 at 0x00000000 Bad eraseblock 1 at 0x00020000 Bad eraseblock 2 at 0x00040000 ................ It seems that it could not find the bad block tables, although on the old barebox they are found. Has someone an idea what I could try to go forward ? ------------------------------------old CONFIG------------------------------------- CONFIG_NAND=y CONFIG_NAND_IMX=y CONFIG_NAND_IMX_BOOT=y # CONFIG_MTD_NAND_VERIFY_WRITE is not set # CONFIG_MTD_NAND_ECC_SMC is not set CONFIG_MTD_NAND_IDS=y ------------------------------------new CONFIG------------------------------------- CONFIG_MTD=y CONFIG_MTD_WRITE=y CONFIG_MTD_OOB_DEVICE=y # CONFIG_MTD_RAW_DEVICE is not set # # Self contained MTD devices # # CONFIG_MTD_DOCG3 is not set CONFIG_NAND=y # CONFIG_NAND_ECC_SOFT is not set CONFIG_NAND_ECC_HW=y # CONFIG_NAND_ECC_HW_SYNDROME is not set # CONFIG_NAND_ECC_HW_NONE is not set CONFIG_NAND_INFO=y CONFIG_NAND_READ_OOB=y CONFIG_NAND_BBT=y CONFIG_NAND_IMX=y # CONFIG_MTD_NAND_VERIFY_WRITE is not set # CONFIG_MTD_NAND_ECC_SMC is not set CONFIG_MTD_NAND_IDS=y Thanks, Gabriel _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
