On Wed, Oct 05, 2011 at 03:44:54PM +0200, Pierre Schirrer wrote: > Hello Sascha, > > >/ > />/ > />/ For the moment, I don't have any activity on my Ethernet ports (no > />/ leds on or blinking), although I added the fec device. When I execute > />/ the dhcp command, I get : > />/ > />/ barebox:/ dhcp > />/ warning: No MAC address set. Using random address 8E:A2:E8:DD:E2:73 > />/ phy0: Link is up - 100/Full > />/ transmission timeout > />/ T transmission timeout > />/ T transmission timeout > />/ > />/ But, whether I connect the cable or not, it always shows "phy0:Link is up - 100/Full". > / > Have a look at the output of md -s /dev/phy0. You should see valid phy > registers, not 0xffffffff. > > > I have exactly the same problem on an i.MX21 board (proprietary > design). I have used the imx21ads to start from. > > md -s /dev/phy0 returns 0xffffffff. Any ideas how to correct this > (the smc91c111 base address is 0xd2c80000) ? Have you used the correct phy address? In the smc91111 driver the phy address is currently hardcoded to 0: priv->miidev.address = 0; Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
