Hi Antony,
On 29.9.2011 г. 16:50 ч., Antony Pavlov wrote:
On 28 September 2011 11:15, Sascha Hauer<s.hauer@xxxxxxxxxxxxxx> wrote:
On Fri, Sep 23, 2011 at 08:57:43AM +0200, Sascha Hauer wrote:
Hi,
The following adds USB mass storage support to barebox. The patches
are from Rosen Kolev, I am just sending these patches for him because
git send-email does not work for him (yet).
Sascha
Rosen Kolev (3):
Modified timeout in the ehci-hcd USB host driver.
Extended USB device matching.
USB mass storage device driver initial implementation
I merged this as-is. There are still some minor things like CamelCase
function names but overall This looked to good to not merge it ;)
This patches have no "Signed-off-by :" label.
I have tried them with 2 USB-flash drives on my Tegra board:
toshiba ac100> / usb
USB: scanning bus for devices...
Bus 001 Device 003: ID 0bdb:190a F3307
Bus 001 Device 004: ID 0bda:58f2 USB Camera
Bus 001 Device 006: ID 8564:1000 Mass Storage Device
disk@disk0: Failed to register partition disk0.1 (-22)
Bus 001 Device 007: ID 067b:2303 USB-Serial Controller
Bus 001 Device 008: ID 8564:1000 Mass Storage Device
register_device: already registered disk0
Bus 001 Device 009: ID 2001:3c05 DUB-E100
eth@eth0: got MAC address from EEPROM: 1C:7E:E5:0F:E1:14
Bus 001 Device 005: ID 05e3:0660 USB2.0 Hub
Bus 001 Device 002: ID 0424:2513
Bus 001 Device 001: ID 0000:0000 EHCI Host Controller
9 USB Device(s) found
Can we register more that one disk?
We were supposed to, but you have just found an omission. In function
usb_stor_add_blkdev(), we need "pdev->id = -1;", e.g. right after "pdev
= &pblk_dev->dev;".
The first error, "Failed to register partition...", probably has
something to do with the partition table. Keep in mind that the disk
driver currently supports up to 2GB partitions.
Regards,
Rosen
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
