Remove several now unnecessary defines. Signed-off-by: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx> --- arch/ppc/boards/pcm030/config.h | 66 +------------------------------------- 1 files changed, 2 insertions(+), 64 deletions(-) diff --git a/arch/ppc/boards/pcm030/config.h b/arch/ppc/boards/pcm030/config.h index a772ee6..e8064d2 100644 --- a/arch/ppc/boards/pcm030/config.h +++ b/arch/ppc/boards/pcm030/config.h @@ -29,80 +29,18 @@ #include <mach/mpc5xxx.h> -/* #define DEBUG */ - -/*------------------------------------------------------------------------------------------------------------------------------------------------------ -High Level Configuration Options -(easy to change) - ------------------------------------------------------------------------------------------------------------------------------------------------------*/ -#define CONFIG_MPC5200_DDR 1 /* (with DDR-SDRAM) */ #define CFG_MPC5XXX_CLKIN 33333333 /* ... running at 33.333333MHz */ -#define BOOTFLAG_COLD 0x01 /* Normal Power-On: Boot from FLASH */ -#define BOOTFLAG_WARM 0x02 /* Software reboot */ - -/*------------------------------------------------------------------------------------------------------------------------------------------------------ -Serial console configuration - ------------------------------------------------------------------------------------------------------------------------------------------------------*/ - -#if (TEXT_BASE == 0xFF000000) /* Boot low */ -#define CFG_LOWBOOT 1 -#endif -/* RAMBOOT will be defined automatically in memory section */ - -/*------------------------------------------------------------------------------------------------------------------------------------------------------ -IPB Bus clocking configuration. - ------------------------------------------------------------------------------------------------------------------------------------------------------*/ -#define CFG_IPBSPEED_133 /* define for 133MHz speed */ -#if defined(CFG_IPBSPEED_133) -/* - * PCI Bus clocking configuration - * - * Actually a PCI Clock of 66 MHz is only set (in cpu_init.c) if - * CFG_IPBSPEED_133 is defined. This is because a PCI Clock of 66 MHz yet hasn't - * been tested with a IPB Bus Clock of 66 MHz. - */ -#define CFG_PCISPEED_66 /* define for 66MHz speed */ -#else -#undef CFG_PCISPEED_66 /* for 33MHz speed */ -#endif -/* we only use CS-Boot */ -#define CFG_BOOTCS_START 0xFF000000 -#define CFG_BOOTCS_SIZE 0x01000000 - -#if CONFIG_MACH_PHYCORE_MPC5200B_TINY_REV == 1 -#define CFG_BOOTCS_CFG 0x0008FD00 -#else -#define CFG_BOOTCS_CFG 0x00083800 -#endif - -/*------------------------------------------------------------------------------------------------------------------------------------------------------ - Memory map - ------------------------------------------------------------------------------------------------------------------------------------------------------*/ -#define CFG_MBAR 0xF0000000 /* MBAR hast to be switched by other bootloader or debugger config */ -#define CFG_SDRAM_BASE 0x00000000 - -/* Use SRAM until RAM will be available */ -#define CFG_INIT_RAM_ADDR MPC5XXX_SRAM -#define CFG_INIT_RAM_SIZE MPC5XXX_SRAM_SIZE /* End of used area in DPRAM */ -#define CONFIG_EARLY_INITDATA_SIZE 0x100 - -#define CFG_BOOTMAPSZ (8 << 20) /* Initial Memory map for Linux */ - -/*------------------------------------------------------------------------------------------------------------------------------------------------------ - GPIO configuration - ------------------------------------------------------------------------------------------------------------------------------------------------------*/ #define CFG_GPS_PORT_CONFIG 0x00558c10 /* PSC6=UART, PSC3=UART ; Ether=100MBit with MD */ -/*------------------------------------------------------------------------------------------------------------------------------------------------------ - Various low-level settings - ------------------------------------------------------------------------------------------------------------------------------------------------------*/ #define CFG_HID0_INIT HID0_ICE | HID0_ICFI #define CFG_HID0_FINAL HID0_ICE #define CFG_CS_BURST 0x00000000 #define CFG_CS_DEADCYCLE 0x33333333 +#define CFG_BOOTMAPSZ (8 << 20) /* Initial Memory map for Linux */ + #define OF_CPU "PowerPC,5200@0" #define OF_TBCLK CFG_MPC5XXX_CLKIN #define OF_SOC "soc5200@f0000000" -- 1.7.6.3 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
