On Fri, Apr 08, 2011 at 12:24:00PM +0200, Marc Kleine-Budde wrote: > This patch adds support for tje mx28-evk board. NAND support is still lacking, > so we use still the bootlets as the first stage boot loader. > > Signed-off-by: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx> > --- > arch/arm/Makefile | 1 + > arch/arm/boards/freescale-mx28-evk/Makefile | 1 + > arch/arm/boards/freescale-mx28-evk/config.h | 16 + > arch/arm/boards/freescale-mx28-evk/env/config | 67 ++++ > arch/arm/boards/freescale-mx28-evk/mx28-evk.c | 378 ++++++++++++++++++++++ > arch/arm/boards/freescale-mx28-evk/tx28-stk5.c | 410 ++++++++++++++++++++++++ Looks like you copied a bit too much from the karo board. > + > +console_initcall(mx28_evk_console_init); > + > +/** > +@page mx28_evk KARO's MX28_EVK CPU module > + > +@section mx28_evk_cpu_card The CPU module > + > +http://www.karo-electronics.de/ > + > +This CPU card is based on a Freescale i.MX28 CPU. The card is shipped with: > + > +- 128 MiB synchronous dynamic RAM (DDR2 type), 200 MHz support > +- 128 MiB NAND K9F1G08U0A (3.3V type) > +- PCA9554 GPIO expander > +- DS1339 RTC > +- LAN8710 Phy > + > +@section mx28_evk_basboards Supported baseboards > + > +Supported baseboards are: > +- KARO's Starterkit 5 > + > +@section mx28_evk_stk5_howto How to get barebox for 'KARO's Starterkit 5' > + > +Using the default configuration: > + > +@verbatim > +make ARCH=arm mx28_evkstk5_defconfig > +@endverbatim > + > +Build the binary image: > + > +@verbatim > +make ARCH=arm CROSS_COMPILE=armv5compiler > +@endverbatim > + > +@note replace the armv5compiler with your ARM v5 cross compiler. > + > +@note To use the result, you also need the following resources from Freescale: > +- the 'bootlets' archive > +- the 'elftosb2' encryption tool > +- in the case you want to start @b barebox from an attached SD card the > + 'sdimage' tool from Freescale's 'uuc' archive. > + > +@section mx28_evk_mlayout Memory layout when barebox is running: > + > +- 0x40000000 start of SDRAM > +- 0x40000100 start of kernel's boot parameters > + - below malloc area: stack area > + - below barebox: malloc area > +- 0x47000000 start of @b barebox Please either correct this or remove it. -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
