Hi Sascha,
On Mon, Jun 28, 2010 at 10:04:42AM +0200, Sascha Hauer wrote:
> On Fri, Jun 25, 2010 at 11:31:49AM +0200, Belisko Marek wrote:
> > I have a calao board sbc35-a9260 with u-boot pre-installed on it.
> > I would like to try barebox running on that board (also make some development).
> > I build at91sam9260ek_defconfig to try it out. I became to situation
> > that I don't know how to load image to board :)
> >
> > I try via tftp but u-boot automatically try to boot it and I got some
> > error about magic number.
> > I think about possibility just download binary to some RAM address and
> > then use go command in u-boot
> > to test if barebox binary will work.
> >
> > There exist some how-to or example how to do this?
>
> It's perfectly fine to start barebox from U-Boot with the 'go' command.
> Try 'setenv autostart no' in U-Boot to stop U-Boot from autostarting
> images.
Is there a way to do the same on Barebox? Currently 'go barebox.bin' in ramfs
returns -EINVAL from memmap.
baruch
--
~. .~ Tk Open Systems
=}------------------------------------------------ooO--U--Ooo------------{=
- baruch@xxxxxxxxxx - tel: +972.2.679.5364, http://www.tkos.co.il -
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
