From: Juergen nogit Beisert <jbe@xxxxxxxxxxxxxx>
Signed-off-by: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>
---
board/freescale-mx35-3-stack/3stack.c | 92 +++++++++++++++++++++++++++++++++
1 files changed, 92 insertions(+), 0 deletions(-)
diff --git a/board/freescale-mx35-3-stack/3stack.c b/board/freescale-mx35-3-stack/3stack.c
index 63f7bba..ecb4037 100644
--- a/board/freescale-mx35-3-stack/3stack.c
+++ b/board/freescale-mx35-3-stack/3stack.c
@@ -47,6 +47,7 @@
#include <mach/iomux-mx35.h>
#include <mach/iomux-v3.h>
#include <mach/pmic.h>
+#include <mach/imx-ipu-fb.h>
#include <i2c/i2c.h>
#include <i2c/mc13892.h>
@@ -111,6 +112,62 @@ static struct device_d i2c_dev = {
.map_base = IMX_I2C1_BASE,
};
+/*
+ * Generic display, shipped with the PDK
+ */
+static struct fb_videomode CTP_CLAA070LC0ACW = {
+ /* 800x480 @ 60 Hz */
+ .name = "CTP-CLAA070LC0ACW",
+ .refresh = 60,
+ .xres = 800,
+ .yres = 480,
+ .pixclock = KHZ2PICOS(27000),
+ .left_margin = 50,
+ .right_margin = 50, /* whole line should have 900 clocks */
+ .upper_margin = 10,
+ .lower_margin = 10, /* whole frame should have 500 lines */
+ .hsync_len = 1, /* note: DE only display */
+ .vsync_len = 1, /* note: DE only display */
+ .sync = FB_SYNC_CLK_IDLE_EN | FB_SYNC_OE_ACT_HIGH,
+ .vmode = FB_VMODE_NONINTERLACED,
+ .flag = 0,
+};
+
+#if 0
+/*
+ * Customers display
+ */
+static struct fb_videomode NEC_NL8048BC19 = {
+ /* 800x480 @ 60 Hz */
+ .name = "NEC-NL8048BC19",
+ .refresh = 60,
+ .xres = 800,
+ .yres = 480,
+ .pixclock = KHZ2PICOS(32256),
+ .left_margin = 112,
+ .right_margin = 112, /* whole line should have 1024 clocks */
+ .upper_margin = 23,
+ .lower_margin = 23, /* whole frame should have 525 lines */
+ .hsync_len = 1, /* note: DE only display */
+ .vsync_len = 1, /* note: DE only display */
+ .sync = FB_SYNC_OE_ACT_HIGH,
+ .vmode = FB_VMODE_NONINTERLACED,
+ .flag = 0,
+};
+#endif
+
+static struct imx_ipu_fb_platform_data ipu_fb_data = {
+ .mode = &CTP_CLAA070LC0ACW,
+ .bpp = 16,
+};
+
+static struct device_d imxfb_dev = {
+ .name = "imx-ipu-fb",
+ .map_base = 0x53fc0000,
+ .size = 0x1000,
+ .platform_data = &ipu_fb_data,
+};
+
static int f3s_devices_init(void)
{
uint32_t reg;
@@ -155,6 +212,7 @@ static int f3s_devices_init(void)
register_device(&smc911x_dev);
register_device(&sdram_dev);
+ register_device(&imxfb_dev);
armlinux_add_dram(&sdram_dev);
armlinux_set_bootparams((void *)0x80000100);
@@ -165,6 +223,14 @@ static int f3s_devices_init(void)
device_initcall(f3s_devices_init);
+static int f3s_enable_display(void)
+{
+ gpio_direction_output(1, 1);
+ return 0;
+}
+
+late_initcall(f3s_enable_display);
+
static struct device_d f3s_serial_device = {
.name = "imx_serial",
.map_base = IMX_UART1_BASE,
@@ -202,6 +268,32 @@ static struct pad_desc f3s_pads[] = {
MX35_PAD_I2C1_DAT__I2C1_SDA,
MX35_PAD_WDOG_RST__GPIO1_6,
+ /* Display */
+ MX35_PAD_LD0__IPU_DISPB_DAT_0,
+ MX35_PAD_LD1__IPU_DISPB_DAT_1,
+ MX35_PAD_LD2__IPU_DISPB_DAT_2,
+ MX35_PAD_LD3__IPU_DISPB_DAT_3,
+ MX35_PAD_LD4__IPU_DISPB_DAT_4,
+ MX35_PAD_LD5__IPU_DISPB_DAT_5,
+ MX35_PAD_LD6__IPU_DISPB_DAT_6,
+ MX35_PAD_LD7__IPU_DISPB_DAT_7,
+ MX35_PAD_LD8__IPU_DISPB_DAT_8,
+ MX35_PAD_LD9__IPU_DISPB_DAT_9,
+ MX35_PAD_LD10__IPU_DISPB_DAT_10,
+ MX35_PAD_LD11__IPU_DISPB_DAT_11,
+ MX35_PAD_LD12__IPU_DISPB_DAT_12,
+ MX35_PAD_LD13__IPU_DISPB_DAT_13,
+ MX35_PAD_LD14__IPU_DISPB_DAT_14,
+ MX35_PAD_LD15__IPU_DISPB_DAT_15,
+ MX35_PAD_LD16__IPU_DISPB_DAT_16,
+ MX35_PAD_LD17__IPU_DISPB_DAT_17,
+ MX35_PAD_D3_HSYNC__IPU_DISPB_D3_HSYNC,
+ MX35_PAD_D3_FPSHIFT__IPU_DISPB_D3_CLK,
+ MX35_PAD_D3_DRDY__IPU_DISPB_D3_DRDY,
+ MX35_PAD_CONTRAST__GPIO1_1,
+ MX35_PAD_D3_VSYNC__IPU_DISPB_D3_VSYNC,
+ MX35_PAD_D3_REV__IPU_DISPB_D3_REV,
+ MX35_PAD_D3_CLS__IPU_DISPB_D3_CLS,
};
static int f3s_console_init(void)
--
1.6.5.2
_______________________________________________
u-boot-v2 mailing list
u-boot-v2@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/u-boot-v2
