From: Conor Dooley <conor.dooley@xxxxxxxxxxxxx>
On Wed, 12 Jun 2024 18:33:31 +0800, Shengyu Qu wrote:
> Currently, for JH7110 boards with EMMC slot, vqmmc voltage for EMMC is
> fixed to 1.8V, while the spec needs it to be 3.3V on low speed mode and
> should support switching to 1.8V when using higher speed mode. Since
> there are no other peripherals using the same voltage source of EMMC's
> vqmmc(ALDO4) on every board currently supported by mainline kernel,
> regulator-max-microvolt of ALDO4 should be set to 3.3V.
>
> [...]
Applied to riscv-dt-fixes, thanks!
[1/1] riscv: dts: starfive: Set EMMC vqmmc maximum voltage to 3.3V on JH7110 boards
https://git.kernel.org/conor/c/3c1f81a1b554
I was kinda holding out for a response for Emil, but I've applied this cos
I'd like to get a fixes PR sent out later this week.
Thanks,
Conor.
