Hi Doug, Thanks for the report. On Tue, Feb 08, 2022 at 09:40:14AM +0800, Doug Smythies wrote: > Hi All, > > Note before: I do not know If I have the e-mail address list correct, > nor am I actually a member of the x86 distribution list. I am on > the linux-pm email list. > > When using the intel_pstate CPU frequency scaling driver with HWP disabled, > active mode, powersave scaling governor, the times between calls to the driver > have never exceeded 10 seconds. > > Since kernel 5.16-rc4 and commit: b50db7095fe002fa3e16605546cba66bf1b68a3e > " x86/tsc: Disable clocksource watchdog for TSC on qualified platorms" > > There are now occasions where times between calls to the driver can be > over 100's of seconds and can result in the CPU frequency being left > unnecessarily high for extended periods. > > >From the number of clock cycles executed between these long > durations one can tell that the CPU has been running code, but > the driver never got called. > > Attached are some graphs from some trace data acquired using > intel_pstate_tracer.py where one can observe an idle system between > about 42 and well over 200 seconds elapsed time, yet CPU10 never gets > called, which would have resulted in reducing it's pstate request, until > an elapsed time of 167.616 seconds, 126 seconds since the last call. The > CPU frequency never does go to minimum. > > For reference, a similar CPU frequency graph is also attached, with > the commit reverted. The CPU frequency drops to minimum, > over about 10 or 15 seconds. commit b50db7095fe0 essentially disables the clocksource watchdog, which literally doesn't have much to do with cpufreq code. One thing I can think of is, without the patch, there is a periodic clocksource timer running every 500 ms, and it loops to run on all CPUs in turn. For your HW, it has 12 CPUs (from the graph), so each CPU will get a timer (HW timer interrupt backed) every 6 seconds. Could this affect the cpufreq governor's work flow (I just quickly read some cpufreq code, and seem there is irq_work/workqueue involved). Can you try one test that keep all the current setting and change the irq affinity of disk/network-card to 0xfff to let interrupts from them be distributed to all CPUs? Thanks, Feng > Processor: Intel(R) Core(TM) i5-10600K CPU @ 4.10GHz > > Why this particular configuration, i.e. no-hwp, active, powersave? > Because it is, by far, the easiest to observe what is going on. > > ... Doug >
