On Tuesday, March 12, 2019 5:57:18 AM CET Viresh Kumar wrote:
> At boot up, CPUfreq core performs a sanity check to see if the system is
> running at a frequency defined in the frequency table of the CPU. If so,
> we try to find a valid frequency (lowest frequency greater than the
> currently programmed frequency) from the table and set it. When the call
> reaches dev_pm_opp_set_rate(), it calls _find_freq_ceil(opp_table,
> &old_freq) to find the previously configured OPP and this call also
> updates the old_freq. This eventually sets the old_freq == freq (new
> target requested by cpufreq core) and we skip updating the performance
> state in this case.
>
> Fix this by also updating the performance state when the old_freq ==
> freq.
>
> Fixes: ca1b5d77b1c6 ("OPP: Configure all required OPPs")
> Cc: v5.0 <stable@xxxxxxxxxxxxxxx> # v5.0
> Reported-by: Niklas Cassel <niklas.cassel@xxxxxxxxxx>
> Signed-off-by: Viresh Kumar <viresh.kumar@xxxxxxxxxx>
> ---
> drivers/opp/core.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/opp/core.c b/drivers/opp/core.c
> index d7f97167cac3..0420f7e8ad5b 100644
> --- a/drivers/opp/core.c
> +++ b/drivers/opp/core.c
> @@ -760,7 +760,7 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
> old_freq, freq);
>
> /* Scaling up? Configure required OPPs before frequency */
> - if (freq > old_freq) {
> + if (freq >= old_freq) {
> ret = _set_required_opps(dev, opp_table, opp);
> if (ret)
> goto put_opp;
>
Applied, thanks!
