At boot up, CPUfreq core performs a sanity check to see if the system is
running at a frequency defined in the frequency table of the CPU. If so,
we try to find a valid frequency (lowest frequency greater than the
currently programmed frequency) from the table and set it. When the call
reaches dev_pm_opp_set_rate(), it calls _find_freq_ceil(opp_table,
&old_freq) to find the previously configured OPP and this call also
updates the old_freq. This eventually sets the old_freq == freq (new
target requested by cpufreq core) and we skip updating the performance
state in this case.
Fix this by also updating the performance state when the old_freq ==
freq.
Fixes: ca1b5d77b1c6 ("OPP: Configure all required OPPs")
Cc: v5.0 <stable@xxxxxxxxxxxxxxx> # v5.0
Reported-by: Niklas Cassel <niklas.cassel@xxxxxxxxxx>
Signed-off-by: Viresh Kumar <viresh.kumar@xxxxxxxxxx>
---
drivers/opp/core.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/opp/core.c b/drivers/opp/core.c
index d7f97167cac3..0420f7e8ad5b 100644
--- a/drivers/opp/core.c
+++ b/drivers/opp/core.c
@@ -760,7 +760,7 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
old_freq, freq);
/* Scaling up? Configure required OPPs before frequency */
- if (freq > old_freq) {
+ if (freq >= old_freq) {
ret = _set_required_opps(dev, opp_table, opp);
if (ret)
goto put_opp;
--
2.21.0.rc0.269.g1a574e7a288b
