On 04/19/2017 10:00 AM, Johan Hovold wrote: > On Tue, Apr 18, 2017 at 08:07:56PM +0200, Marek Vasut wrote: >> This development kit has an FT4232 on it with a custom USB VID/PID. >> The FT4232 provides four UARTs, but only two are used. The UART 0 >> is used by the FlashPro5 programmer and UART 2 is connected to the >> SmartFusion2 CortexM3 SoC UART port. >> >> Note that the USB VID is registered to Actel according to Linux USB >> VID database, but that was acquired by Microsemi. >> >> Signed-off-by: Marek Vasut <marex@xxxxxxx> >> Cc: stable <stable@xxxxxxxxxxxxxxx> >> Cc: usb <linux-usb@xxxxxxxxxxxxxxx> >> Cc: Johan Hovold <johan@xxxxxxxxxx> >> --- >> V2: - Move the ID in ftdi_sio_ids.h to keep it sorted by VIDs >> - Use the JTAG quirk to avoid binding channel 0, this is needed by >> the Libero software, otherwise it cannot use the programmer. >> V3: - Remove the verbose comment >> - Use USB_DEVICE_INTERFACE_NUMBER() instead of the JTAG quirk > > Applied for -next, thanks. Super, thanks. -- Best regards, Marek Vasut