This development kit has an FT4232 on it with a custom USB VID/PID.
The FT4232 provides four UARTs, but only two are used. The UART 0
is used by the FlashPro5 programmer and UART 2 is connected to the
SmartFusion2 CortexM3 SoC UART port.
Note that the USB VID is registered to Actel according to Linux USB
VID database, but that was acquired by Microsemi.
Signed-off-by: Marek Vasut <marex@xxxxxxx>
Cc: stable <stable@xxxxxxxxxxxxxxx>
Cc: usb <linux-usb@xxxxxxxxxxxxxxx>
Cc: Johan Hovold <johan@xxxxxxxxxx>
---
V2: - Move the ID in ftdi_sio_ids.h to keep it sorted by VIDs
- Use the JTAG quirk to avoid binding channel 0, this is needed by
the Libero software, otherwise it cannot use the programmer.
V3: - Remove the verbose comment
- Use USB_DEVICE_INTERFACE_NUMBER() instead of the JTAG quirk
---
drivers/usb/serial/ftdi_sio.c | 1 +
drivers/usb/serial/ftdi_sio_ids.h | 4 ++++
2 files changed, 5 insertions(+)
diff --git a/drivers/usb/serial/ftdi_sio.c b/drivers/usb/serial/ftdi_sio.c
index 80c6d3deb80d..91a4d7346549 100644
--- a/drivers/usb/serial/ftdi_sio.c
+++ b/drivers/usb/serial/ftdi_sio.c
@@ -873,6 +873,7 @@ static const struct usb_device_id id_table_combined[] = {
{ USB_DEVICE_AND_INTERFACE_INFO(MICROCHIP_VID, MICROCHIP_USB_BOARD_PID,
USB_CLASS_VENDOR_SPEC,
USB_SUBCLASS_VENDOR_SPEC, 0x00) },
+ { USB_DEVICE_INTERFACE_NUMBER(ACTEL_VID, MICROSEMI_ARROW_SF2PLUS_BOARD_PID, 2) },
{ USB_DEVICE(JETI_VID, JETI_SPC1201_PID) },
{ USB_DEVICE(MARVELL_VID, MARVELL_SHEEVAPLUG_PID),
.driver_info = (kernel_ulong_t)&ftdi_jtag_quirk },
diff --git a/drivers/usb/serial/ftdi_sio_ids.h b/drivers/usb/serial/ftdi_sio_ids.h
index 168ccb03ce08..58cf17d362c5 100644
--- a/drivers/usb/serial/ftdi_sio_ids.h
+++ b/drivers/usb/serial/ftdi_sio_ids.h
@@ -877,6 +877,10 @@
#define FIC_VID 0x1457
#define FIC_NEO1973_DEBUG_PID 0x5118
+/* Microsemi/Arrow SF2PLUS Dev Kit */
+#define ACTEL_VID 0x1514
+#define MICROSEMI_ARROW_SF2PLUS_BOARD_PID 0x2008
+
/* Olimex */
#define OLIMEX_VID 0x15BA
#define OLIMEX_ARM_USB_OCD_PID 0x0003
--
2.11.0