Based on what you configured you cisco router? what did you configured
on your cisco router?
What cisco device are you using?
did you had the chance to look at:
http://wiki.squid-cache.org/ConfigExamples/UbuntuTproxy4Wccp2
please try to share more information on the infrastructure and the whole
squid.conf removing only confrontational INFO.
Did you had the chance to use TPROXY before?
Did you tried to sniff with tcpdump?
Eliezer
On 1/2/2013 3:38 AM, Roman Gelfand wrote:
I use wccp/gre tunnel. Port 80
requests work but 443 don't. I am not sure if this is right, but even
though data was received on wccp, no data was transmitted back over
wccp. In other words, squid server response was routed back, through
eth0 interface, rather than go through wccp0 interface. Is this
expected behavior? If not, what do I do to make
response go over wccp?
my iptable config look like this
iptables -t nat -A PREROUTING -i wccp0 -p tcp --dport 80 -j DNAT --to
192.168.5.81:3228
iptables -t nat -A PREROUTING -i wccp0 -p tcp --dport 443 -j DNAT --to
192.168.5.81:3229
and squid.conf
wccp2_service dynamic 90
wccp2_service_info 90 protocol=tcp priority=240 ports=80,443
