Hi All, I successfully resolved this problem. Thanks, Benjamin On Wed, Oct 12, 2011 at 8:01 PM, benjamin fernandis <benjo11111@xxxxxxxxx> wrote: > Hi > > > Please guide me to clear my queries. > > > Thanks, > Benjamin > > On Tue, Oct 11, 2011 at 7:22 PM, benjamin fernandis > <benjo11111@xxxxxxxxx> wrote: >> Hi All, >> >> We have requirement to configure squid to deploy with cisco wccp2. >> >> I have some confusion regarding configuration, kindly clear my queries >> and guide me to configure it. >> >> >> My current network senario: >> >> Wan side cisco 7200 router ( wan ip 84.24.xx.xx ) ( lan ip >> 149.255.xx.xx) ( lan ip is bgp routed ip pool ) >> | >> | >> switch ---------------------squid box ( one >> interface only ip : 149.255.xx.19) ( gateway ip is router lan ip ) >> | >> | >> End Users >> >> >> Now i need to configure squid to use with wccp. >> >> >> >> i tried to find reference document from google and squid wiki. But i >> have some queries, >> >> >> what is remote ip while configuring ip tunnel in squid and local ip ? >> >> as per my current configuration i tried : remote ip is router wan ip ( >> 84.24.xx.xx) and local ip is squd ip ( 149.255.xx.xx ) >> >> >> is it correct one ? >> >> >> and what is the wccp2_router router ip in squid.conf >> >> i used 149.255.xx.xx ( router lan ip ) >> >> is it correct one ? >> >> >> --------------------------------------------------------------------------------- >> test 1 >> >> actually i tried to configure router loop back ip on tunnel remote and >> squid ip as local ip on tunnel but that time i can see traffic on wccp >> interface and traffic on iptables nat redirection rule but no traffic >> in squid access.log and surfing is not working. >> >> ------------------------------------------------------------------------------------------------ >> >> So please guide me , what could be right configuration while going to >> use squid with wccp2. >> >> >> OS: fedora 15 >> squid : 3.1.14 >> >> >> Regards, >> Benjo >> >
