Hi, I'm currently testing Squid 2.6.STABLE1. In the past I have always used Squid as a reverse proxy to our http servers on the internal network, today as I'm setting up Squid I notice it's missing something in the Squid.conf file. I just went through and configure everything as I had on the old Squid box but there is only one option under the httpd-accelerator section. # HTTPD-ACCELERATOR OPTIONS # ---------------------------------------------------------------------------- - # TAG: httpd_accel_no_pmtu_disc on|off # In many setups of transparently intercepting proxies Path-MTU # discovery can not work on traffic towards the clients. This is # the case when the intercepting device does not fully track # connections and fails to forward ICMP must fragment messages # to the cache server. # # If you have such setup and experience that certain clients # sporadically hang or never complete requests set this to on. # #Default: # httpd_accel_no_pmtu_disc off Then I check the FAQ and followed this link http://wiki.squid-cache.org/SquidFaq/ReverseProxy to read more about how to set it up. It says to use the options httpd_accel_host and httpd_accel_port but they're not valid options when I start Squid, it gives me an error. 2006/07/03 16:20:13| parseConfigFile: line 2967 unrecognized: 'httpd_accel_host virtual' 2006/07/03 16:20:13| parseConfigFile: line 2968 unrecognized: 'httpd_accel_port 80' I didn't have any problems configuring it in 2.5.STABLE14 release. Further searching the squid.conf for the term "httpd_accel" returns nothing except the above option. Am I doing something wrong? I checked if needed to compile it with options to enable reverse proxy but I don't. Thank you, Jon
