The hyperSPARC boots, but fails when starting init. It runs fine on 2.6.17. [ 11.116665] VFS: Mounted root (ext3 filesystem) readonly on device 8:20. [ 11.123332] Freeing unused kernel memory: 108k freed [ 11.186665] init[1]: segfault at 0 ip 5000dac8 (rpc f000eea8) sp efe738a0 error 30001 in ld-2.3.5.so[50000000+1a000] [ 12.029998] Kernel panic - not syncing: Attempted to kill init! [ 12.033332] [f002ed74 : do_group_exit+0x84/0xb4 ] [f0039a24 : get_signal_to_deliver+0x338/0x35c ] [f0011fbc : do_signal+0x30/0x914 ] [f00128b4 : do_notify_resume+0x14/0x38 ] [f000fd50 : signal_p+0x14/0x24 ] [f000eea8 : srmmu_fault+0x58/0x68 ] [ 12.079998] Press Stop-A (L1-A) to return to the boot prom The superSPARC is running ... # uname -a Linux viking 2.6.38-rc2-up #4 Sat Mar 5 22:15:54 CET 2011 sparc sun4m Texas Instruments, Inc. - SuperSparc-(II) GNU/Linux SPARCstation 20 MP (2 X SuperSPARC-II), No Keyboard ROM Rev. 2.25, 448 MB memory installed, Serial #8021487. Ethernet address 8:0:20:7a:65:ef, Host ID: 727a65ef. Boot device: /iommu/sbus/espdma@f,400000/esp@f,800000/sd@3,0 File and args: SILO Version 1.4.13 boot: Loaded kernel version 2.6.38 PROMLIB: obio_ranges 5 OF stdout device is: /obio/zs@0,100000:a Booting Linux... [ 0.000000] PROMLIB: Sun Boot Prom Version 3 Revision 2 [ 0.000000] Linux version 2.6.38-rc2-up (root@jalapeno) (gcc version 4.4.4 (Gentoo 4.4.4-r2 p1.3, pie-0.4.5) ) #4 Sat Mar 5 22:15:54 CET 2011 [ 0.000000] ARCH: SUN4M [ 0.000000] TYPE: Sun4m SparcStation10/20 [ 0.000000] Ethernet address: 08:00:20:7a:65:ef [ 0.000000] Boot time fixup v1.6. 4/Mar/98 Jakub Jelinek (jj@xxxxxxxxxxxxxx). Patching kernel for srmmu[TI Viking/MXCC]/iommu [ 0.000000] 255MB HIGHMEM available. [ 0.000000] OF stdout device is: /obio/zs@0,100000:a [ 0.000000] PROM: Built device tree with 26777 bytes of memory. [ 0.000000] Power off control detected. [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 112944 [ 0.000000] Kernel command line: root=/dev/sda4 [ 0.000000] PID hash table entries: 1024 (order: 0, 4096 bytes) [ 0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) [ 0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) [ 0.000000] Memory: 445352k/457964k available (1872k kernel code, 12612k reserved, 484k data, 108k init, 261356k highmem) [ 0.000000] SLUB: Genslabs=15, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:64 [ 0.000000] Console: colour dummy device 80x25 [ 0.000000] console [tty0] enabled [ 0.000000] Calibrating delay loop... 74.60 BogoMIPS (lpj=124160) [ 0.059999] pid_max: default: 32768 minimum: 301 [ 0.059999] Mount-cache hash table entries: 512 [ 0.066666] NET: Registered protocol family 16 [ 0.089999] IOMMU: impl 1 vers 3 table 0xfbc80000[262144 B] map [65536 b] [ 0.099999] bio: create slab <bio-0> at 0 [ 0.106666] SCSI subsystem initialized [ 0.146666] NET: Registered protocol family 2 [ 0.146666] IP route cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.149999] TCP established hash table entries: 8192 (order: 4, 65536 bytes) [ 0.149999] TCP bind hash table entries: 8192 (order: 3, 32768 bytes) [ 0.153333] TCP: Hash tables configured (established 8192 bind 8192) [ 0.153333] TCP reno registered [ 0.153333] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.153333] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.156666] highmem bounce pool size: 64 pages [ 0.233333] msgmni has been set to 359 [ 0.236666] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253) [ 0.236666] io scheduler noop registered [ 0.236666] io scheduler deadline registered (default) [ 0.246666] ffd5c3c0: ttyS0 at MMIO 0xf1100000 (irq = 8) is a zs (ESCC) [ 0.246666] Console: ttyS0 (SunZilog zs0) [ 0.253333] console [ttyS0] enabled [ 0.256666] ffd5c3c0: ttyS1 at MMIO 0xf1100004 (irq = 8) is a zs (ESCC) [ 0.266666] ffd5c4a0: Keyboard at MMIO 0xf1000000 (irq = 8) is a zs [ 0.273333] ffd5c4a0: Mouse at MMIO 0xf1000004 (irq = 8) is a zs [ 0.283333] esp: esp0, regs[fd00a000:fd009000] irq[2] [ 0.286666] esp: esp0 is a FAS100A, 40 MHz (ccf=0), SCSI ID 7 [ 3.293333] scsi0 : esp [ 4.003332] scsi 0:0:3:0: Direct-Access FUJITSU MAP3735N SUN72G 0401 PQ: 0 ANSI: 4 [ 4.006666] scsi target0:0:3: Beginning Domain Validation [ 4.013332] scsi target0:0:3: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 15) [ 4.016666] scsi target0:0:3: Domain Validation skipping write tests [ 4.019999] scsi target0:0:3: Ending Domain Validation [ 4.503332] scsi 0:0:6:0: CD-ROM PLEXTOR CD-R PX-W4220T 1.04 PQ: 0 ANSI: 2 [ 4.509999] scsi target0:0:6: Beginning Domain Validation [ 4.516666] scsi target0:0:6: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 8) [ 4.523332] scsi target0:0:6: Domain Validation skipping write tests [ 4.526666] scsi target0:0:6: Ending Domain Validation [ 4.536666] esp: esp1, regs[fd00c000:fd00b000] irq[7] [ 4.539999] esp: esp1 is a FASHME, 40 MHz (ccf=0), SCSI ID 7 [ 7.546665] scsi1 : esp [ 11.069998] mousedev: PS/2 mouse device common for all mice [ 11.073332] rtc-m48t59 rtc-m48t59.0: rtc core: registered m48t08 as rtc0 [ 11.076665] TCP cubic registered [ 11.083332] rtc-m48t59 rtc-m48t59.0: setting system clock to 2007-04-29 05:49:08 UTC (1177825748) [ 11.093332] sd 0:0:3:0: [sda] 143374738 512-byte logical blocks: (73.4 GB/68.3 GiB) [ 11.099998] sd 0:0:3:0: [sda] Write Protect is off [ 11.106665] sd 0:0:3:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [ 11.126665] sda: sda1 sda2 sda3 sda4 sda5 sda6 sda7 [ 11.139998] sd 0:0:3:0: [sda] Attached SCSI disk [ 11.156665] EXT3-fs: barriers not enabled [ 11.166665] kjournald starting. Commit interval 5 seconds [ 11.169998] EXT3-fs (sda4): mounted filesystem with ordered data mode [ 11.173332] VFS: Mounted root (ext3 filesystem) readonly on device 8:4. [ 11.179998] Freeing unused kernel memory: 108k freed INIT: version 2.86 booting [ 12.723332] NET: Registered protocol family 1 Gentoo Linux; http://www.gentoo.org/ Copyright 1999-2007 Gentoo Foundation; Distributed under the GPLv2 blahblah... INIT: Entering runlevel: 3 blahblah... login: Marcel On Sat, Mar 5, 2011 at 5:25 PM, Sam Ravnborg <sam@xxxxxxxxxxxx> wrote: > On Sat, Mar 05, 2011 at 03:49:08PM +0100, Marcel van Nies wrote: >> Hi Sam, >> >> > The patchset will likely not see testing on: >> > - Javastation (the pcic changes) >> > - sun4m with multiple CPUs >> > - sun4c >> > >> > I have checked the nearby ebay's for relevant boxes - no luck. >> > On the other hand there is also a limit for the size of >> > my SUN museum :-) >> >> I've got a small "SUN museum" ... >> sun4c: SPARCstation IPX >> sun4m: SPARCstation5 (microSPARC II) >> sun4m: SPARCstation20 (two-way superSPARC II) >> sun4m: SPARCstation20 (four-way hyperSPARC Colorado-3) >> >> Never got the IPX running on 2.6, but the others are spinning just >> fine on some 2.6.1x UP (x=low). >> I'm looking forward to give your patchset a try. > > Great! > > If you fetch sparc-next-2.6.git: > > git://git.kernel.org/pub/scm/linux/kernel/git/davem/sparc-next-2.6.git > > then you only need to apply the patch from this mail: > > http://marc.info/?l=linux-sparc&m=129823440700712&w=2 > > I'm looking forward for the result of the tests. > > Sam > -- To unsubscribe from this list: send the line "unsubscribe sparclinux" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
