On 10/10/2013 01:31 PM, William Roberts wrote: > set it as: s2,s3 (if you can even do that not sure if it works like cats) No, can't do that with sensitivities. > > > On Thu, Oct 10, 2013 at 1:12 PM, Langland, Blake < > blangland@xxxxxxxxxxxxxxxxxx> wrote: > >> All,**** >> >> ** ** >> >> I have two web servers running on an SELinux machine, one running at s2 >> and one at s3. Both webservers have two webapps each that are attempting to >> communicate over the loopback interface. The communication is strictly s2 >> <-> s2 and s3 <-> s3. The problem I am having is setting the MLS level of >> the loopback interface. If I have it set below s3, the s3 webapps cannot >> send over the interface; If I have it set higher than s2, the s2 webapps >> cannot receive over the interface. Any suggestions?**** >> >> ** ** >> >> Thanks,**** >> >> Blake**** >> >> ** ** >> > > > -- This message was distributed to subscribers of the selinux mailing list. If you no longer wish to subscribe, send mail to majordomo@xxxxxxxxxxxxx with the words "unsubscribe selinux" without quotes as the message.
