Re: User Process fault 0x7 on S390 installation under VM

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Nov 14, 2003 at 12:04:43PM -0500, Mike Mays wrote:

> I am attempting to install (2.4.9-37BOOT) under VM using CTC's to
> connect to VM/TCPIP.   The installation gets as far as entering the IP
> address of the VM Partner, then fails with several "User process fault
> 0x7" messages.  an ifconfig screen later in the script shows no CTC
> interface is defined other than lo. 
> 
> CTC's are all defined to VM Correctly, and an installed  version of
> TurboLinux runs successfully using the same definitions. 

My first guess is that it's out of memory somehow.
How much storage do you have defined on that guest?

-- Pete
_______________________________________________
Redhat-s390-list mailing list
Redhat-s390-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/redhat-s390-list

[Index of Archives]     [Fedora General Discussion]     [LKML]     [Red Hat Install]     [Red Hat Watch]     [Red Hat Development]     [Linux s390]     [Gimp]     [Yosemite News]

  Powered by Linux