--- Arindam Dey <adey@xxxxxxxxxx> wrote: > On Wed, 2003-07-23 at 16:52, mick mearns wrote: > > Hello list; > > I have the above SCSI controller. > > I downloaded the 2.6 source and installed it. > > It compiles fine under RH9. > > The 2.6 failure is in the make initrd for the AIC7xxx > > > > My method: > > 'cd /usr/src/*2.6*' > > 'make mrpoper' > > I copied my working RH9 .config and used > > 'make menuconfig' > > I tried making everything scsi with no modules, and with all > modules. > > Then 'make bzImage modules modules_install install' > > > > I get an initrd error 'error AIC7xxx no module:' > > I am on a different machine right now and don't have the full error > > display. > > I do have a /initrd directory. > > Have u done this in make menuconfig? > > SCSI device support ---> SCSI low-level drivers ---> Adaptec AIC7xxx > Fast -> U160(New > Driver) > > Have you built it in the kernel <*> or made a module out of this <M> > ? > > ls /lib/modules/2.6.0-test1/kernel/drivers/scsi/aic7xxx/ what is the > output of this ? Does it list aic7xxx.o ? > > I am currently compiling and having another adaptec card which also > uses > the same module I was interested. > > > -- > Arindam Dey > Hello; thank you for your reply. I tried both methods (M and *), with the same result. The bzImage gets made fine and then the initrd fails. I am not at that box right now, will look tomorrow. Mick M. __________________________________ Do you Yahoo!? Yahoo! SiteBuilder - Free, easy-to-use web site design software http://sitebuilder.yahoo.com -- Shrike-list mailing list Shrike-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/shrike-list
