Hi experts
Origianlly installed IDE controller on the motehrboad seemed
malfunctioning on one of our desktops, so I added a Belkin Ultra ATA/133
PCI card [F5U098] to an open IDE slot.
Two slots [primary/slave] on the card are now connected to CDROM and
hard drive with IDE cables.
On boot, it does not detect any primary/slave drive, then Belkin RAID
controller kicks in by asking if I want to setup RAID device. It
acutally searches primary/slave channel on the new card and finds both
CDROM and hard drive before asking RAID setup. After I gets out of raid
setup or simply ignores radi setup, the boot agent on desktop cannot
detect any devices connected to Belkin PCI card.
I just want to boot from a CDROM drive and install redhat to the hard
drive through Belkin card.
Could you advise me how to setup bios or where to look into ? I
played with DMA/PCI IRQs and device settings on original BIOS, but it
did not help at all.
Thanks,
yasushi
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
