Make sure the partition labels in fdisk are set to "Linux Raid Autodetect" Thanks, Tom Callahan TESSCO Technologies Desk: (410)-229-1361 Cell: (443)-506-6216 Email: callahant@xxxxxxxxxx A real engineer only resorts to documentation when the keyboard dents on the forehead get too noticeable. baran.yurdagul@xxxxxxxxxxxxxxx wrote: >Can you make some full fsck to filesystem ? > >-----Original Message----- >From: redhat-list-bounces@xxxxxxxxxx >[mailto:redhat-list-bounces@xxxxxxxxxx] On Behalf Of Marc Leveille >Sent: Friday, January 27, 2006 3:50 PM >To: General Red Hat Linux discussion list >Subject: RE: Help with ES v3 Raid1 (Mirror) > >Hi, I used ext3. I will try again today using ext2 as I have no other >idea. I only have experience with hardware raid with Windows. > >thanks > >Marc > >On Fri, 2006-01-27 at 08:09 +0200, baran.yurdagul@xxxxxxxxxxxxxxx wrote: > > >>Which option did u use while creating the filesystem, ext2 or ext3 via >>mkfs command ? >> >>-----Original Message----- >>From: redhat-list-bounces@xxxxxxxxxx >>[mailto:redhat-list-bounces@xxxxxxxxxx] On Behalf Of Marc Leveille >>Sent: Thursday, January 26, 2006 9:52 PM >>To: redhat-list@xxxxxxxxxx >>Subject: Help with ES v3 Raid1 (Mirror) >> >>Hi, I'm trying to setup a Raid1 mirror between 2 hard drives. I have >> >> >the > > >>following. >> >>1- SDA 36gig System disk >>2- SDB 36gig blank >>3- SDC 36gig blank >> >>I'm trying to Mirror SDB to SDC by doing the following. >> >>1- By using FDisk I created SDB1 and SDC1 on each drive. >>2- I then makefs ext3 for each partition. >>3- Then I used mkadm --create /dev/md0 --level=1 >>--raid-devices=2 /dev/sdb1 /dev/sdc1 >> >>I ran watch cat /proc/mdstat until the process was completed. >>4- when it was complete I tested the mount using mount -t >>ext3 /dev/md0 /home/apps and it mounted and I was able to open it. >>5- I then edited fstab with /dev/md0 /home/apps ext3 defaults 1 2 and >>rebooted. >>6- I now get the following error at boot. >> >>FSCK.ext3 /dev/mdo the superblock could not be read or does not >> >> >describe > > >>a correct EXT2 Filesystem.......bla bla and asks to run E2FSCK -B 8193 >> >>7- I used Vi and comented out the mount in fstab and re-booted. I >> >> >tried > > >>to manually mount the drive the same way as (Item #4) and it now fails >>Mount: Wrong FS Type. >> >>Any ideas as to what I need to do. Sould I use ext3 ? >> >>thanks >> >>Marc >> >>-- >>redhat-list mailing list >>unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe >>https://www.redhat.com/mailman/listinfo/redhat-list >> >> >> >> >> >************************************************************************ > > >>Bu elektronik posta ve onunla iletilen butun dosyalar sadece >> >> >gondericisi tarafindan almasi amaclanan yetkili gercek ya da tuzel >kisinin kullanimi icindir. Eger soz konusu yetkili alici degilseniz bu >elektronik postanin icerigini aciklamaniz, kopyalamaniz, yonlendirmeniz >ve kullanmaniz kesinlikle yasaktir ve bu elektronik postayi derhal >silmeniz gerekmektedir. > > >>TURKCELL bu mesajin icerdigi bilgilerin dogrulugu veya eksiksiz oldugu >> >> >konusunda herhangi bir garanti vermemektedir. Bu nedenle bu bilgilerin >ne sekilde olursa olsun iceriginden, iletilmesinden, alinmasindan ve >saklanmasindan sorumlu degildir. Bu mesajdaki gorusler yalnizca gonderen >kisiye aittir ve TURKCELLin goruslerini yansitmayabilir > > >>Bu e-posta bilinen butun bilgisayar viruslerine karsi taranmistir. >> >> >> >************************************************************************ > > >>This e-mail and any files transmitted with it are confidential and >> >> >intended solely for the use of the individual or entity to whom they are >addressed. If you are not the intended recipient you are hereby notified >that any dissemination, forwarding, copying or use of any of the >information is strictly prohibited, and the e-mail should immediately be >deleted. > > >>TURKCELL makes no warranty as to the accuracy or completeness of any >> >> >information contained in this message and hereby excludes any liability >of any kind for the information contained therein or for the information >transmission, reception, storage or use of such in any way whatsoever. >The opinions expressed in this message belong to sender alone and may >not necessarily reflect the opinions of TURKCELL. > > >>This e-mail has been scanned for all known computer viruses. >> >> >> >************************************************************************ > > >> >> > > > -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
