I have just acquired an old Dell P166 desktop to use as a firewall, and it had a 3Com 3c905 on board. It was detected using the 3c59x module and worked without a problem. I have now added a second 3Com 3c905 network card (PCI) to the system, and it appears that this one is also working perfectly.
However, the new add-in card is now eth0 and the onboard network is eth1. Just out of sheer idle curiosity, is there a way I can swap those two so that the onboard is eth0 and the add-in is eth1?
-- Rodolfo J. Paiz rpaiz@xxxxxxxxxxxxxx
-- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
