On 22/01/2023 at 06:05, H wrote:
The new one uses two disks, RAID1, LUKS and LVM for everything but
/boot and /boot/efi, total of four partitions (swap has its own
partition - not sure why I made it that way). A minimal installation of
Centos 7 was made to this setup and is working. In other words, UUIDs
of disks, partitions and LUKS are already configured and working.
So, I am now thinking the following might work:
- Make a rsync backup of the new disks to the external harddisk
("BACKUP2").
- Delete all files from the new disks except from /boot and /boot/efi.
- Copy all files from all partitions except /boot and /boot/efi from
BACKUP1 to the new disks. In other words, everything except /boot and
/boot/efi will now be overwritten.
- I would expect this system not to boot since both /etc/fstab and
/etc/crypttab on the new disks contain the UUIDs from the old system.
- Copy just /etc/fstab and /etc/crypttab from BACKUP2 to the new disks.
This should update the new disks with the previously created UUIDs from
when doing the minimal installation of CentOS 7.
What do you think?
There are caveats:
- The kernel versions must be the same in the old and new systems so
that kernel images in /boot and kernel modules in /lib/modules match.
- Make sure that mdadm is installed in the old system. For now it is
included in the initramfs generated by the new system but if mdadm is
not installed in the old system, newer initramfs generated by the old
system will fail to mount the root filesystem.
I am happy to share that my plan as outlined below worked. I now have
/boot, /boot/efi and / on separate RAID partitions with the latter
managed by LVM and encrypted. All data from the old disk is now on
the new setup and everything seems to be working.
However, going back to the issue of /boot/efi possibly not being
duplicated by CentOS, would not mdadm take care of that automatically?
How can I check?
Is really /boot/efi on RAID ? You can check with "lsblk".
If it is, can you post the output of
cat /proc/mdstat
fdisk -l
blkid
efibootmgr -v
PS: Your lines are too long.
