On 9/24/2011 10:16 AM, David Brown wrote:
On 24/09/2011 14:17, Stan Hoeppner wrote:
On 9/23/2011 7:11 PM, Thomas Fjellstrom wrote:
On September 23, 2011, Stan Hoeppner wrote:
When properly configured XFS will achieve near spindle throughput.
Recent versions of mkfs.xfs read the mdraid configuration and configure
the filesystem automatically for sw, swidth, number of allocation
groups, etc. Thus you should get max performance out of the gate.
What happens when you add a drive and reshape? Is it enough just to
tweak the
mount options?
When you change the number of effective spindles with a reshape, and
thus the stripe width and stripe size, you definitely should add the
appropriate XFS mount options and values to reflect this. Performance
will be less than optimal if you don't.
If you use a linear concat under XFS you never have to worry about the
above situation. It has many other advantages over a striped array and
better performance for many workloads, especially multi user general
file serving and maildir storage--workloads with lots of concurrent IO.
If you 'need' maximum single stream performance for large files, a
striped array is obviously better. Most applications however don't need
large single stream performance.
If you use a linear concatenation of drives for XFS, is it not correct
that you want one allocation group per drive (or per raid set, if you
are concatenating a bunch of raid sets)?
Yes. Normally with a linear concat you would make X number of RAID1
mirrors via mdraid or hardware RAID, then concat them with mdadm
--linear or LVM. Then mkfs.xfs -d ag=X ...
Currently XFS has a 1TB limit for allocation groups. If you use 2TB
drives you'll get 2 AGs per effective spindle instead of one. With some
'borderline' workloads this may hinder performance. It depends on how
many top level directories you have in the filesystem and your
concurrency to them.
If you then add another drive
or raid set, can you grow XFS with another allocation group?
XFS creates more allocation groups automatically as part of the grow
operation. If you have a linear concat setup you'll obviously wan to
control this manually to maintain the same number of AGs per effective
spindle.
Always remember that the key to linear concat performance with XFS is
directory level parallelism. If you have lots of top level directories
in your filesystem and high concurrent access (home dirs, maildir, etc)
it will typically work better than a striped array. If you have few
directories and low concurrency, are streaming large files, etc, stick
with a striped array.
Also note that a linear concat will only give increased performance with
XFS, again for appropriate worklods. Using a linear concat with EXT3/4
will give you the performance of a single spindle regardless of the
total number of disks used. So one should stick with striped arrays for
EXT3/4.
--
Stan
--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
