On Mon, 17 May 2010 20:10:36 +0200 Pierre Vignéras <pierre@xxxxxxxxxxxxx> wrote: > Did I miss something, or is there something really strange happening there? Something strange... I cannot explain the 'SpareActive' messages. Most of the rest makes sense. You had a RAID10 - 4 drives in near=2 mode. So the first two disks contain identical data, and the second two are also identical and contain the rest. The second device failed due to a write error. Why it seemed to become a spare I'm not sure. I'm not all sure it did become a spare immediately- your logs aren't conclusive on that point. It did eventually become a spare, but that could be because you "removed and added the devices" which would have changed them from 'fail' to 'spares'. Then the first device in the array reported an error and so was failed. After this you would not be able to read or write to the even chunks of the array, xfs noticed and complained. By this time sdf1 seemed to be a spare so it gave recovery a try. The recovery process discovered there was nowhere to read good data from and immediately gave up. However if the devices really are OK, then sdf1 and sdc1 should contain identical data (except the superblock would be slightly different. You could check this with "cmp -l", though that might not be very efficient. Also sdd1 and sde1 should be identical. I suggest that you try: mdadm -S /dev/md2 mdadm -C /dev/md2 -l 10 -n 4 -c 64 -e 0.90 /dev/sdc1 missing /dev/sdd1 missing --assume-clean and then see what the data on md2 looks like. You could equally try sdf1 in place of sdc1, or sde1 in place of sdd1 (make sure you double check the device names, don't assume I got then right). Once you have a combination that look good, you can add the other two devices an they will recover and you should have your data back. BUT be warned. Something cause some errors to be reported. Unless you find out what that was and fix it, errors will occur again. I have no idea what might have caused those errors. Bad media? bad controller ? bad usb controller? bad luck? I wouldn't write new data, or even perform a recovery until you are quite confident of the devices. NeilBrown -- To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
