On Thu, 10 May 2007, Liang Yang wrote:
Hi,
I created a MD-RAID5 array using 8 Maxtor SAS Disk Drives (chunk size is
256k). I have measured the data transfer speed for single SAS disk drive
(physical drive, not filesystem on it), it is roughly about 80~90MB/s.
However, I notice MD also reports the speed for the RAID5 array when it is
being initialized (cat /proc/mdstat). The speed reported by MD is not
constant which is roughly from 70MB/s to 90MB/s (average is 85MB/s which is
very close to the single disk data transfer speed).
I just have three questions:
1. What is the exact meaning of the array speed reported by MD? Is that
mesured for the whole array (I used 8 disks) or for just single underlying
disk? If it is for the whole array, then 70~90B/s seems too low considering 8
disks are used for this array.
2. How is this speed measured and what is the I/O packet size being used when
the speed is measured?
3. From the beginning when MD-RAID 5 array is initialized to the end when the
intialization is done, the speed reports by MD gradually decrease from 90MB/s
down to 70MB/s. Why does the speed change? Why does the speed gradually
decrease?
Could anyone give me some explanation?
I'm using RHEL 4U4 with 2.6.18 kernel. MDADM version is 1.6.
Thanks a lot,
Liang
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
For no 3. because it starts from the fast end of the disk and works its
way to the slower part (slower speeds).
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
