Guess hdparm -z /dev/md12 would do the trick, if you're lucky enough...
2006/5/30, Herta Van den Eynde <herta.vandeneynde@xxxxxxxxxxxxxx>:
I'm trying to add a new SAN LUN to a system, create a multipath mdadm
device on it, partition it, and create a new filesystem on it, all
without taking the system down.
All goes well, up to partitioning the md device:
# fdisk /dev/md12
Device contains neither a valid DOS partition table, nor Sun, SGI
or OSF disklabel
Building a new DOS disklabel. Changes will remain in memory only,
until you decide to write them. After that, of course, the
previous content won't be recoverable.
The number of cylinders for this disk is set to 8569312.
There is nothing wrong with that, but this is larger than 1024,
and could in certain setups cause problems with:
1) software that runs at boot time (e.g., old versions of LILO)
2) booting and partitioning software from other OSs
(e.g., DOS FDISK, OS/2 FDISK)
Warning: invalid flag 0x0000 of partition table 4 will be
corrected by w(rite)
Command (m for help): p
Disk /dev/md12: 35.0 GB, 35099901952 bytes
2 heads, 4 sectors/track, 8569312 cylinders
Units = cylinders of 8 * 512 = 4096 bytes
Device Boot Start End Blocks Id System
Command (m for help): n
Command action
e extended
p primary partition (1-4)
p
Partition number (1-4): 1
First cylinder (1-8569312, default 1):
Using default value 1
Last cylinder or +size or +sizeM or +sizeK (1-8569312, default
8569312):
Using default value 8569312
Command (m for help): w
The partition table has been altered!
Calling ioctl() to re-read partition table.
WARNING: Re-reading the partition table failed with error 22:
Invalid argument.
The kernel still uses the old table.
The new table will be used at the next reboot.
Syncing disks.
I know a reboot will read the new table, but is there any way to clear
the in-memory table and replace it with the newly written one?
The entire point of this exercise is to be able to add diskspace without
having to reboot.
Kind regards,
Herta
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
