A followup about one single question.
tmp wrote: []
Is it correct that I can use whole disks (/dev/hdb) only if I make a partitionable array and thus creates the partitions UPON the raid mechanism?
Just don't use whole disks for md arrays. *Especially* if you want to create partitions inside the array. Instead, create a single partition (/dev/hdb1) - you will waste the first sector on the disk, but will be much safer. The reason is trivial:
Linux raid subsystem is designed to leave almost the whole underlying device from its very beginning to almost the end for the data, it stores its superblock (metadata information) at the *end* of the device (this way, you can mount eg a single component of your raid1 array without md layer at all, for recovery purposes).
Whenever you will use the whole disk, /dev/hdb, for the raid arrays, or not, kernel will still look at the partition table in the disk. This table is at the very beginning of it. If md array is at the whole disk, very beginning of the disk is the same as the very beginning of the array. So, kernel may recognize something written to the start of the array as a partition table, and "activate" all the /dev/hdbN devices.
This is especially the case when you create partitions *inside* the array (md1p1 etc) -- the same partition table (now valid one) will be seen in /dev/hdb itself *and* in /dev/md1.
Now, when kernel recognized and activated partitions this way, the partitions physically will reside somewhere inside the array. For one, it is unsafe to access the partitions, obviously, and the kernel will not warn/deny your accesses.
But it is worse. Suppose you're assembling your arrays by searching all devices for a superblocks. The device you want is /dev/hdb, but kernel recognized partitions on it, and now the superblock is at the end of both /dev/hdb and the last partition on it, say, /dev/hdb4 -- you're lucky if your raid assembly tools will pick up the right one... (Ok ok, the same applies to normal partitions as well: it's always ambiguous choice if your last partition is a part of a raid array, what to chooce: the last partition or the whole disk)
Also suppose you will later want to boot from this drive, eg because your real boot drive failed - you will have to actually move your data off by a single sector to free the room for real partition table...
To summarize: don't leave the kernel with more than one choice. It's trivial to avoid the whole issue, with some more yet unknown to me possible bad sides, by just creating a single partition on the drive and be done with it, once and forever.
/mjt - To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
