On 18 March, 2017 - Tadej Panjtar wrote: > Thanks! > ... > > If PA is started via command as root it works. But if same command > is run via systemd, happens Got signal SIGTERM. > Here is log. ... > mar 18 00:14:11 tadejas pulseaudio[8285]: Got signal SIGTERM. ... > and here is service script: > > # systemd service spec for pulseaudio running in system mode -- not > recommended though! > # put it under /etc/systemd/system/pulseaudio.service > # start with: systemctl start pulseaudio.service > # enable on boot: systemctl enable pulseaudio.service > > [Unit] > Description=Plseaudio Service > After=network-online.target > > [Service] > ExecStart=/usr/bin/pulseaudio -vvvv --system --disallow-exit > --disallow-module-loading > #ExecReload=/bin/kill -HUP $MAINPID > TimeoutSec=13 I guess this is your problem. 13 seconds after start systemd sends a SIGTERM, because it thinks the service didn't start properly. //Anton > > [Install] > WantedBy=multi-user.target > > Best regards, > Tadej > > > > On Fri, Mar 17, 2017 at 3:16 AM, Arun Raghavan <arun at arunraghavan.net> > wrote: > > > On Wed, 15 Mar 2017, at 12:27 PM, Tadej Panjtar wrote: > > > Hi! > > > > > > I Migrated from pulseaudio version 4.0 to 8.0 and the following command > > > does not work anymore: > > > load-module module-alsa-sink device="hw:2,7" sink_name=seat1 > > > > > > E: [pulseaudio] module.c: Failed to load module "module-alsa-sink" > > > (argument: "device="hw:2,7" sink_name=seat1"): initialization failed. > > > E: [pulseaudio] main.c: Module load failed. > > > > > > What is wrong? > > > > You need to increase your pulseaudio debug level (or start it with > > -vvvv). > > > > -- Arun > > > _______________________________________________ > pulseaudio-discuss mailing list > pulseaudio-discuss at lists.freedesktop.org > https://lists.freedesktop.org/mailman/listinfo/pulseaudio-discuss -- Anton Lundin +46702-161604