Hi,
when a sink is started, there is some delay before the first sample is
really played.
This delay is a constant part of the sink latency that will be always
present, so the
minimum sink latency cannot go below that start delay.
Would it be acceptable to adjust the latency range for the device after
each unsuspend
to reflect that?
USB devices (those I have access to) for example have a startup delay in
the range of
10ms, but have a latency range that starts at 0.5ms which does not make
a lot of sense
in my opinion.
The startup delay is not constant, so the minimum possible latency would
vary.
On the source side the startup delay is not relevant since it does not
delay the signal.
Regards
Georg
