I'm a bit new to using PulseAudio. So two programs can connect to the same source? What API do I use to do this? I apologize if this has been answered. I appreciate the help. Thanks, Craig On 02/05/2014 06:47 PM, Arun Raghavan wrote: > Hi Craig, > > On 3 February 2014 21:13, Craig Matsuura <cmatsuura at vivint.com> wrote: > [...] >> pactl load-module module-loopback >> source="alsa_input.pci-0000_00_1b.0.analog-stereo" >> sink="alsa_output.usb-0d8c_C-Media_USB_Headphone_Set-00-Set.iec958-stereo" >> pactl load-module module-loopback >> source="alsa_input.usb-0d8c_C-Media_USB_Headphone_Set-00-Set.analog-mono" sink="alsa_output.pci-0000_00_1b.0.analog-stereo" >> >> The above two commands allow me to connect the sink/source from one card >> to another. I now want to listen in-band and detect DTMF tones or >> possibly other audio capture. How can I do this keeping my two cards >> connected as above? > Any reason you couldn't just run a capture stream as you normally > would on the source(s) that you want to listen in on? > > Cheers, > Arun > _______________________________________________ > pulseaudio-discuss mailing list > pulseaudio-discuss at lists.freedesktop.org > http://lists.freedesktop.org/mailman/listinfo/pulseaudio-discuss
