Dear Tanu:
Thank you for your mail, I mainly use this command: /system/bin/pulseaudio -system to run the pulseaudio.
As shown in the attachment. In my board don't have this file /etc/pulse/default.pa, could you told me how to disable
loading the startup script? and also could you send the default.pa file to me? Thank you very much.
Best regards,
Dongjiu Geng
-----Original Message-----
From: Tanu Kaskinen [mailto:tanuk@xxxxxx]
Sent: Wednesday, October 17, 2012 7:24 PM
To: Dongjiu Geng
Cc: General PulseAudio Discussion
Subject: Re: Issue: running error
On Tue, 2012-10-16 at 23:51 -0700, Dongjiu Geng wrote:
> HI all:
> I port the pulseaudio to my DKB board, when I run the pulseaudio,
> it print the log: "Daemon startup without any loaded modules, refusing to work"
> and exit, and also can not connect to the pulseaudio. Could you tell me what
> should I do about that ? Thank you very much in advance.
Pulseaudio should load some modules from a startup script
(normally /etc/pulse/default.pa). What command line did you use to start
pulseaudio? Either you disabled loading the startup script, or you don't
have /etc/pulse/default.pa installed.
--
Tanu
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.freedesktop.org/archives/pulseaudio-discuss/attachments/20121017/e733953f/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: run.sh
Type: application/octet-stream
Size: 310 bytes
Desc: run.sh
URL: <http://lists.freedesktop.org/archives/pulseaudio-discuss/attachments/20121017/e733953f/attachment.obj>
