Hi, I have been using PJSIP version 0.8 in a demo softphone application for quite a while and recently started using its NAT callbacks to check the type of NAT detected by PJNATH. I observed that often it reports NAT type as Symmetric, even though the NAT type (as checked using WinStun) is Restricted or Port Restricted. However this issue is intermittent; mostly the correct NAT is reported. Is it a known issue in 0.8 which has been fixed in some later version? Regards Girish **************** CAUTION - Disclaimer ***************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system. ***INFOSYS******** End of Disclaimer ********INFOSYS*** -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.pjsip.org/pipermail/pjsip_lists.pjsip.org/attachments/20081023/02f8186a/attachment-0001.html>
