-----Original Message----- From: Miles Thompson [mailto:milesthom@xxxxxxxxx] Sent: 15 May 2007 08:21 To: PHP List Subject: PHP debugger I am trying to load a PHP debugger in our most recent build of PHP 5.2.1. The debugger which I am trying to set up is the free, pre-compiled Linux version of dbg ( DBG 2.15.5 dbg modules), from http://dd.cron.ru/dbg/, and all of the instructions have been followed as posted on the NuSphere site. Yes, Apache has been stopped and restarted!! There is no difference in the output from phpinfo(). The line "with DBG v2.11.30, (C) 2000,2004 by Dmitri Dmitrienko, http://dd.cron.ru"; does not appear. PHP is compiled without debugging, but I did consider that was for the purpose of debugging PHP itself, not scripts. Suggestions will be most welcome. Also, I'm not married to this, so if anyone thinks there is a better debugger, please jump in. Regards - Miles Thompson
< snipped some trivial comments>
On 5/16/07, Arno Kuhl <akuhl@xxxxxxxxxxxx> wrote:
If you don't see any change in phpinfo then maybe it's not picking up the dbg extension in your php.ini. Presumably you've also put the other debugger directives in your ini? You can also try download the trial version of PHPEd from Nusphere, install that, and check how it configures the debugger. The trial lasts a month I think, so maybe you'll sort out your problems in that time anyway. Just be sure to completely uninstall it afterwards because I think the free dbg version is not the same as the version integrated in PHPEd. Any version differences cause the extension to not load, though in that case it should report an error. You can't use the dbg integrated in PHPEd after uninstall because it doesn't work without PHPEd. Arno
From my php.ini ....
; added debug extension "dbg.so-5.2.x" and ; see [debugger] section of this file - 20050515 - mthompson ; extension=dbg.so ;dbg.so-5.2.x and the [debugger] section ... ; Added [debugger] section 20050515 - mthompson ; Note: DBG versions 2.15 (free) does not support debugger.hosts_allow, ; debugger.hosts_deny or debugger.ports settings. ; [debugger] debugger.enabled=on debugger.profiler_enabled=on debugger.hosts_allow= <<inserted domain and IP number here>> debugger.hosts_deny=ALL debugger.ports=7869, 10000/16 ; end [debugger] section Couple of notes: 1. Tried this with extension pointing to both dbg.so and dbg.so-5.2.x. (The latter is what the instructions specified, but that did not seem correct.) 2. Also tried it, in combination with above, with debugger.hosts_allow, debugger.hosts_deny and debugger.ports all commented out. 3. PHP version is 5.2.1, compiled from source on a Ubuntu Edgy Eft server. I'm wondering it I should download the source and compile it. That might be a better way home than assuming the binary is correct. Arno, your suggestion to install the NuSphere editor is a good one. I'm just reluctant to add more junk to my Windows box and to allow something other than atp-get / dselect to mess with server configuration. (Although it is a development box, so errors are not terminal!) Thanks to everyone for suggestions. Regards - Miles -- PHP General Mailing List (http://www.php.net/) To unsubscribe, visit: http://www.php.net/unsub.php
