Il 06/11/14 16:47, John R Pierce ha scritto:
On 11/6/2014 7:36 AM, Edoardo Panfili wrote:
grep localhost /etc/hosts
127.0.0.1 localhost
127.0.1.1 host.host host
wahaaaa?
whats the output of ...
# ifconfig lo
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:18367154 errors:0 dropped:0 overruns:0 frame:0
TX packets:18367154 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:23279985092 (21.6 GiB) TX bytes:23279985092 (21.6
GiB)
# ifconfig lo
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:3306 errors:0 dropped:0 overruns:0 frame:0
TX packets:3306 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2544659 (2.4 MiB) TX bytes:2544659 (2.4 MiB)
note that net mask? the loopback interface is the entire
127.0.0.0/8 network you can't put a host at 127.0.1.x and expect it
to work right.
you should instead use one of the RFC1918 reserved subnets for a
private network, within 10.0.0.0/8 or 172.16.0.0/12, or
192.168.0.0/16 (you can use these with any mask size you want, for
instance, /24 is usually used with 192.168.x.y)
I can't figure why 127.0.1.1 is there (I will remove it) is an (almost)
new installation on a virtual machine,
Edoardo
--
Sent via pgsql-general mailing list (pgsql-general@xxxxxxxxxxxxxx)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-general
